Maintenance
Analysis of Common Faults of Gear Pumps for Compaction Garbage Trucks
1. Reasons for the oil pump not discharging oil or insufficient flow
The pump doesn't rotate.
The oil suction pipe or oil suction filter is clogged
The amount of hydraulic oil is too low
The internal components of the pump are worn or damaged
The seal is damaged.
Exclusion method
The spline of the pump is damaged or the power take-off cannot be engaged
Analyze, inspect and repair, and clear blockages
Add hydraulic oil to the specified height
Replace or repair replacement
2. Reasons for high noise and large pressure fluctuations
The oil suction pipe or oil suction filter is clogged
There is a large amount of air in the oil circuit
The internal components of the pump are worn or damaged
The oil is contaminated or emulsified
Exclusion method
Analyze, inspect and repair, and clear blockages
Exhaust
Replace or repair
Change the hydraulic oil
3. Causes of abnormal fever
There is a large amount of air in the oil circuit
The amount of hydraulic oil is too low
System blockage
Exclusion method
Exhaust
Add hydraulic oil to the specified height
Analyze, inspect and repair, and clear blockages
Related articles
- Analysis and Judgment of the Causes of Crankshaft Ablation
- Analysis and Elimination of Common Faults of Excavators
- Fault Analysis of ABG423 Paver
- Analysis and Prevention of Abnormal Wear and Early Damage of Piston Rings in High-Strength Diesel En
- Analysis of the Reasons for Insufficient Power of the 913 Series Diesel Engine
- Maintenance methods and measures for common hydraulic systems of construction machinery
- A Brief Discussion on the Maintenance of Hydraulic Systems in Commonly Used Construction Machinery
- Analysis of the Causes of low engine Oil pressure
- Cost Analysis and Control of Asphalt Recycling Mixing Equipment
- Analysis of Common Accidents of Tower Cranes
